for now i did the ori bars and mesh in the grille but darkened in between and below the bonnet line a deep red line , lower part probable will get a ic

again the ori beside it to see and compare the change till now






and here a nice hudge size for detail and cleannes 2000x1333 > http://img227.imageshack.us/img227/5890/chop3candyapple18.jpg

intercooler / oilcooler idea



right after i posted this i noticed i didnt like the lighting on the inside bar of the vent (right side)
it made the center vent look depthless on the right side (i know it was like that but...)
so re-brushed that to a darker red , it now looks deeper and imo better

better indeedy, nice ic, keep it up

HI RIch
Just thought i would help you with the rear wheel as i noticed it was a bit strange,
its looking great good work til now


glac

thnx , but i'm not getting what you mean
compared for ages i can only see you added a piece on the left lower side

is that what you mean that you think there is too little tyre on the left bottom side ??

haha no RIch, i changed the wheel angle and Twisted it so it didt have so much negative chamber

check here

yours http://img232.imageshack.us/img232/1798/chop3candyapple19.jpg

Mine http://www.cstormark.com/Wheelfix.jpg

see the rear wheel difference

glac

hey glacius ,

i looked in ps , maybe this solves the problem as well ?
instead of getting rid of the strecht tyre look on the left / making the tyre fatter (was like that) i made the right side come to the tyre

so the skirt and wheel well more towards the back ..

HI Rich

No no its not that the issue mate, its the rim thats not correct, compare mine again with yours you see i twisted the rim , you see it ?
I aligned it with the body of the car , your looked off thats all, just do what you want mate i just wanted to point out this =) cheers

aah i understand
we posted together before this

thnx m8

will try that , although i must admit i did the camber a bit too much on purpose to get a bit of forward motion effect (cant explain really )

anyway i cf-ed the hood and roof (i also tried to put cf on the nose but that looked utter stupid )

and then cleaned the outlines (thats why the black is there)
the ori outlines where really fyzzy and choppy
i even changed the roofoutline so its not that bulky



detail / pattern

and then did the grille bars in cf and the door piece
used smaller pattern off-course



zooms to see the pattern (needs to be less obvious)